Skip to content

Use a Mac's Internet Sharing

How-to · Help with Part 1 · 1:49

A Mac plugged into your router can share its internet over Wi-Fi for the ticker: pick a 2.4 GHz channel and WPA2/WPA3 Personal security.

Step by step in the manual: Using a computer as a hotspot

Chapters

  1. 0:00Two reasons
  2. 0:43Turn on Internet Sharing
  3. 1:08Set the ticker up on it
  4. 1:17What the test tells you

More help with Part 1

Read it insteadHide the text

Is your ticker too far from the router? A Mac that stays on beside it can give it a Wi-Fi of its own, with Internet Sharing.

It's also a quick test. If the ticker joins the Mac's Wi-Fi, but not your home Wi-Fi, the ticker is fine.

The Mac shares a connection it gets some other way, usually an Ethernet cable to your router, out over Wi-Fi.

Pick channel 1, 6 or 11. Those are three of the 2.4 gigahertz channels, the band the ticker hears.

Keep the security on WPA2/WPA3 Personal. WPA3 Personal on its own locks the ticker out.

And keep the Mac awake.

Open System Settings, General, then Sharing. Turn on Internet Sharing, and click Configure.

Share your connection from Ethernet. Under, to devices using, turn on Wi-Fi.

Give the network a name, pick channel 11, keep WPA2/WPA3 Personal, and set a password. Click OK, then Done.

Now set the ticker up from your phone, as in our setup videos, and pick the Mac's Wi-Fi by the name you gave it.

The ticker joins the Mac, and shows prices.

If the ticker runs on the Mac's Wi-Fi, but not on your home Wi-Fi, look at your router. Usually it's one of these: the 2.4 gigahertz band switched off or merged into one name, WPA3-only security, protected management frames set to required, or a list that has to approve new devices.